© 2019 Columbus McKinnon Corporation. All Rights Reserved
4
LHH-B P/N 192063327
REV. AA March 2019
Adjustment
If a Load Limiter equipped hoist cannot lift rated load,
or less, then the Load Limiter is not set properly or is
malfunctioning. The slip torque must be adjusted or
the Load Limiter must be replaced.
Precautions
If the hoist does not operate in the “up” direction while
the Load Limiter is functioning properly, eliminate
overload conditions such as greater than rated load,
anchored load, or obstructed load.
Only Qualified Persons should attempt to
disassemble/assemble, repair, or adjust the Load
Limiter.
Load Limiters are pre-set from the factory. Do not
attempt to tighten or loosen the locknut.
Do not attempt to clean the Load Limiter with cleaning
solutions. Do not attempt to lubricate the Load Limiter.
Remove adhered dust or dirt on the Load Limiter using
a cloth.
Moisture absorption may degrade the performance of
the Load Limiter.
Remove dirt from the unit and keep it at ordinary
temperature in a dry condition for storage.
Converting Standard Units with
Optional Load Limiter
(0.5t
-
5t capacity units)
1.
Loosen and remove hand wheel cover nuts and
split-washers/lockwashers.
2.
Remove the hand wheel cover.
3.
Remove the hand chain.
4.
Remove the split/cotter pin, castle nut, and flat
washer.
