1.5 REAR PANEL CONNECTIONS
1.
AC power cord input jack -- plug the power cord in here.
2.
Fuse holder -- A 3-ampere medium delay fuse should be used..
3.
Printer Connection -- A standard IBM printer cable should be connected between
this output jack and the printer. (Refer to section 1.31)
4.
RS-232 Serial Port -- A 9 pin to 25 pin serial cable connects this output to the serial
port of your computer. The output only uses three lines. It is a standard "modem"
connection with the output data on pin 3 and the input on pin 2. Pin 7 is the ground
connection. The data rate is fixed at 9600 baud: the format is 8 bits, one stop bit,
with no parity bit. (Refer to section 1.32)
5.
Footswitch Input -- The footswitch input is a monophonic 1/4" phone jack on the
rear panel of the Tail-Flick. It is designed to be used with a normally open,
momentary contact pushbutton ie: footswitch. The footswitch input is connected in
parallel with the front panel "START / STOP" switch. In the TIMER mode the
footswitch is depressed and held until a “flick” is detected. In AUTO DETECT
mode the footswitch is depressed and released and the unit will detect the “flick”.
8
Содержание Tail-Flick Analgesia Meter
Страница 3: ...SECTION 1 SPECIFICATIONS 2...
Страница 10: ...SECTION 2 OPERATION 9...
Страница 16: ...SECTION 3 TECHNICAL NOTES ACCESSORIES 15...