2
COLUMBIA SPECIFICATIONS MODELS N2F AND N2F48
1622 Browning Irvine, CA 92606-4809 Phone: 949.474.0777 Toll Free: 800.626.2117 Fax: 949.474.1191 www.columbiasinks.com email: [email protected]
©2013 Columbia Products
INDUSTRIAL SPRAY FOAMER/SANITIZER
Tip Color
Hole Dia.
Size in Drill No.
Ratio
Oz. Per Gal.
No Tip
12:01
10
Gray
.128
30
*
*
Black
.098
40
*
*
Beige
.070
50
*
*
Red
.052
55
*
*
White
.043
57
14:01
9
Blue
.040
60
16:01
8
Tan
.035
65
18:01
7
Green
.028
70
26:01:00
5
Orange
.025
72
32:01:00
4
Brown
.023
74
*
*
Yellow
.020
76
42:01:00
3
Aqua
.018
77
*
*
Purple
.014
79
64:01:00
2
Pink
.010
87
128:01:00
1
Operation
1. Unscrew the lid assembly from container.
2. Use the chart below to select a metering tip.
3. Press the tip firmly into the bottom of the lid assembly. Then install the suction tube onto lid
over the metering tip. (Illustration A and B)
3. Fill the container with concentrate. Screw the lid assembly securely onto container to prevent
any accidental spilling.
4. Make sure that the aluminum quick connect coupler is attached to the spray nozzle model
N2. (Illustration C)
5. Connect hose with ¾” GHT male threads to model N2 spray nozzle inlet. Turn on the water
supply with minimum of 25 PSI.
6. Hold the spray nozzle handle in one hand and the container in the other and squeeze the
spray nozzle handle to begin.
When using this product you should always:
1. Wear protective clothing and eyewear when dispensing chemicals or other materials or when
working in the vicinity of all chemicals, filling or emptying equipment or changing metering tips.
2. Observe safety and handling instructions of the chemical manufacturers.
3. Direct discharge away from you or other persons or into approved containers.
4. Dispense cleaners and chemicals in accordance with manufacturer’s instructions. Exercise
caution when maintaining your equipment.
5. Clean all equipment after each use in accordance with instruction sheet.
6. Re-assemble equipment according to instruction procedures. Be sure all components are
firmly screwed or latched into position.
7. Use only to tap water outlets with a maximum psi of 85.
Metering Tip Selection
The below listed dilution ratios were found using 40 PSI, cold water and water-thin viscosity (1.0
CP). Ratios will vary based on PSI, water and ambient temperature and viscosity. If no tip is
listed then the dilution ratio falls between those shown.
Parts List
(1) Model N2 spray nozzle
(1) Model N2FC aluminum coupler
(1) Model N2FL or N2F48L foamer lid kit (includes suction tube and foot strainer)
(1) Model N2FSL or N2FSL4 sanitizer lid kit (includes suction tube and foot strainer)
(1) 96 oz. or 48 oz. container
(1) Model N2FM metering tip kit with 15 colored tips (see chart below)
Illustration A
Illustration B
Illustration C
