Columbia CR-10 Chariot, Руководство по обслуживанию

Страница: 22 / 23

4.8 TREADLE – Figure 4.8.1
To remove:

Follow the steps for rear wheel hub removal in
Section 4.7.

Disconnect the speed control arm (A) from the
front of the treadle.

Disconnect the treadle to brake linkage from the
treadle.

Remove the two spindle mounting screws from
each of the treadle mounts (B).

Remove the treadle and treadle mounts.
To install:

Install the two screws through the treadle mounts
into the spindles. Torque both screws to 150 inch
pounds. Tighten the lower mounting screws
securely with an open end wrench.

Connect the treadle to the brake linkage to the
treadle.

Connect the speed control arm to the treadle.
4.9 SPINDLE
To remove:

Follow the steps for rear wheel hub removal in Section 4.7 for both spindles. On the drive wheel side
spindle follow the procedures outlined in the brake installation Section 4.2.

Remove the two spindle mounting screws from each of the treadle mounts (Figure 4.8.1 B).

Remove the lower mounting screws from each of the spindle(s) and remove the spindle(s).
To install:

Install the lower mounting screws into the spindles. Do not tighten.

Install two screws through the treadle mounts into the spindles. Torque screws to 150 inch pounds.

Tighten the lower mounting screws securely with an open end wrench.

On the drive wheel side spindle follow the procedures outlined in the brake installation Section 4.2.
4.10 CHARGER– Figure 4.10.1
To remove:

Disconnect batteries, negative cable first.

Remove the charger cover plate.

Disconnect the DC output leads from the motor
(A) and solenoid (B).

Disconnect the wires from the keyswitch (C) and
battery state of charge meter which is located
under the keyswitch.

Remove the remaining mounting screws from the
charger,

Remove the charger from the vehicle.
NOTICE: Placing a block between the vehicle
sides to spread them slightly will ease in
removal and installation of the charger.
A
B
Figure 4.8.1
4-6
C
A
B
Figure 4.10.1