COLUMBIA VAC KLC9050, Руководство пользователя

Страница: 28 / 44

28
Timer
Turn on the device by pressing the „D” button.
Select the required operating mode of the device (information above).
Press button „A” - digits will start flashing on the display „K”.
Use buttons „C” and „E” to select a time from 1 to 24 hours.
After selecting the time, wait for the digits on the display to stop flashing.
To disable the function, press the „A” button and use the „C” and „E” buttons to set the numbers
„00” on the display.
Changing the operating mode is possible when the „TIMER” function is active.
Button lock
To activate the button lock, press and hold the “G” button for a few seconds.
Function activation is indicated by the indicator light.
When the lock is active, you cannot change the appliance settings or turn it off.
To deactivate the lock, press and hold the dimmed “G” button for a few seconds.
WATER DISCHARGE
The unit is equipped with an evaporation system. Liquefied water is used to cool the
condenser, which increases the cooling efficiency and reduces energy consumption.
If the water level in the system reaches the maximum level, the letters (FT) will appear on the
display „K” and the compressor will stop running.
Manual removal of water – drawing 6.
Switch off the device and move it to a place where water can be drained from it.
Remove the plug from the hole „14” and carefully drain the water.
Insert the plug into the hole „14”.
Turn the device on again.
Constant water drainage – drawing 7.
Turn the appliance off.
Remove the plug from the hole „10”.
Mount the rubber tube (not included) and place its other end in a container, e.g. a bucket.
MAINTENANCE
Note: Turn off the unit and unplug it before any maintenance or repair begins to avoid
electric shock.
Cleaning
· Unplug the unit before any cleaning.
· Clean the housing with a soft moisture cloth. Do not use chemical solvent (such as benzene,
alcohol, gasoline). The surface may be damaged or even the whole case may be deformed.
· Do not sprinkle water on the unit.
Air filter – drawing 8.
· Clean the air filter every 2 weeks. If the air filter is blocked with dust, the efficiency will reduce.
· Open the air filter cover upwards, and then take out the air filter.
· Wash the air filter by immersing it gently into warm (about 40oC) water with a neutral detergent,
rinse it and dry it thoroughly in a shaded place.