COLUMBIA VAC KLC9050, Руководство пользователя

Страница: 27 / 44

27
In the event of a power loss and a change in operating mode, there is a 3-minute delay until
the compressor restarts to protect the compressor.
Cooling
Turn on the device by pressing the „D” button.
Press the „F” key until the „J” indicator lights up.
Use buttons „C” and „E” to set the temperature in the range from 16°C to 32°C.
The fan speed is set using button „B”.
The current room temperature is shown on the display „K”.
The air-conditioner will turn off when the room temperature drops below the set temperature.
When using cooling mode, the exhaust air pipe must be connected to the unit.
Fan
In this mode, only the unit’s fan operates.
Switch on the appliance using button „D”.
Press the „F” button until the „H” indicator is illuminated.
The fan speed (low, high) is set using button „B”.
To switch off, press the „F” button (change mode) or the „D” button (switch off the device).
Dehumidification
Turn on the device by pressing the „D” button.
Press the „F” key until the „I” indicator lights up.
The dehumidifier runs continuously - the humidity level cannot be set.
The fan only runs at low speed.
When using dehumidify mode, the exhaust air pipe must be connected to the unit to allow
moisture to escape.
Connect the hose to the condensate drain on the bottom of the unit. Place the end of the hose
in a suitable container or in the water drain of the room.
Night mode
The night mode only works in conjunction with the cooling mode.
The night mode is activated by pressing the „R” button on the remote control.
The fan only runs at low speed.
After 1 hour from starting the mode, the set temperature is increased by 1°C, after another hour the
set temperature will be increased by 1°C again.
The temperature is then held constant for 10 hours.
And all indicators are dimmed.
To disable the mode, press the „R” button on the remote control once again.
Start delay
The device must be switched off but connected to the power supply.
Press button „A” - digits will start flashing on the display „K”.
Use buttons „C” and „E” to select a time from 1 to 24 hours.
After selecting the time, wait for the digits on the display to stop flashing.
Select the required operating mode of the device (information above).
To disable the function, press the „A” button and use the „C” and „E” buttons to set the numbers
„00” on the display.