SG Series Technical Manual
Page 8 of 10
19. Run the calibration and auto-
stitch processes.
NOTE: It maybe that the alignment moves
during focusing, and the auto-stitch should
bring it back in. If not the scanner will need to
be returned for alignment, as this is not
possible in the field.
20. To refit the Rear Inner Cover
make sure the edge of the
cover sits in the recess of the
scanner.
21. Replace 2 x M3 lower screws
to hold the Rear Inner Cover
in place, but do not tighten.
22. Replace the 5 x M3 upper
screws into the recesses of
the Rear Inner Cover.
NOTE: It is worth magnitising the screwdriver,
or using some form of sticky putty to hold the
screw to the screwdriver to refit the screws.
