1
Slim Pace Clocks
Product Description
Slim Pace Clocks display time for time of day and pacing purposes. Clocks set to the
same channel and PAN ID will automatically synchronize with each other. Six-digit
clocks display hours, minutes and seconds. Four-digit clocks can display either hours and
minutes, or minutes and seconds. Synchronization is controlled by an internal certified
radio with an internal patch antenna which is protected from damage. The clocks feature
an indoor/outdoor metal enclosure with a slim profile and a plastic weather cover over the
digits.
Mounting and Power Connection
Setting Channel and PAN
Slim pace clocks set to the same channel and PAN will automatically synchronize with
each other.
The default factory settings are channel 4 and PAN 0.
To change these:
1.
Make certain the unit is disconnected from AC power.
2.
Remove the weather cover by turning the slotted studs a quarter turn using a
flathead screwdriver so that they are vertical. Remove the weather cover and set it
in a safe place
3.
Remove the second digit from the left. Using a Phillips head screwdriver, unscrew
the retaining screws and set them in a safe place. Carefully lean the digit against
the enclosure.
4.
Set the channel and PAN using the dip switches on the circuit board:
DIP switch settings
(Off = 0, On = 1)
Channels:
Switches
1-4 of S2
. 0 to 11 are valid
PAN ID:
Switches
5-8 of S2
. 0 to 15 are valid
0 0 0 0 0
0 0 1 0 4
0 0 0 1 8
0 0 1 1 12
1 0 0 0 1
1 0 1 0 5
1 0 0 1 9
1 0 1 1 13
0 1 0 0 2
0 1 1 0 6
0 1 0 1 10
0 1 1 1 14
1 1 0 0 3
1 1 1 0 7
1 1 0 1 11
1 1 1 1 15
NOTE: switches 6-8 of S1, should not be changed.
Doing so will cause the unit to cease functioning properly.
Switches 1-5 of S1 have no effect for Slim Pace Clocks, and do not need to be set.
5.
Reattach the digit and replace the weather cover. Turn the slotted studs to
horizontal. They will snap into place with moderate pressure.
