Colonial Label Thermal System, Руководство пользователя, Страница: 4 / 17

How to set up the new system:
1.
2.
3.
4.
5.
6.
7.
Plug power supply into power cord then into back of printer and into power
outlet.
Plug keypad into back of printer and tighten screws securely.
Power on/off switch is located on right side of printer toward the back. Green
light will appear when printer is on.
Load Labels.
Check to make sure ribbon is in tight. It could loosen during
shipping.
One way to make sure the ribbon is in tight is to open machine and pull the ribbon
carriage down. On the left hand side there is a white wheel, put one finger on the
white wheel and one finger on the opposite side and squeeze it together as hard as
you can - close machine.
Power on unit (on/off) switch is located on the right side of the printer at the
bottom.
Never power the unit off by just unplugging it.
The green light will appear around the green feed button on the top.
Do a test print. The first one or two labels print off line. The third label should
print like the sample labels you were sent.
3
Ribbon Supply
Spindle
Ribbon
Take-Up
Spindle
Ribbon
Sensor
White
Wheel
Ribbon
Take-Up
Gear
Top Cover
Lock
Media Guide
Adjuster Knob
Opposite
Side