Collomix BIAX 45P, Инструкция по эксплуатации

Страница: 10 / 24

BIAX 45P Collomix GmbH
10 Version 1.7-18
5. Set-up and using the Mixer for the first time
When setting up the machine, the applicable electrical requirements and the additional information
in this Operating Instructions must be followed.
5.1 Content
The biaxial mixer is delivered with the following:

These Operating Instructions

A PERMA
©
lubrication cartridge

A rubber band to secure the handles

A power supply cord
5.2 Set-up the equipment
The machine is delivered on a wooden pallet packaged in recyclable cardboard. Check the packaging
immediately upon receipt and the equipment when unwrapping it for any visual external defects.
Keep all parts of the original packaging for a possible necessary return.
The machine shall be operated only by qualified personnel using suitable lifting equipment eg. a
forklift truck to be lifted from the palette. Only move the fork in from the front or back to avoid
damaging the transport rollers (5.3)!
Pay attention to the weight of the machine specified in 11.1 not to exceed the permissible load of
the floor.
Do not operate the machine on the shipping pallet or on any other suitable sub-surfaces.
Before installation, ensure that there is a sufficiently large working area available in front of the
machine. The doors of the machine may not protrude into aisles or travel paths when opened!
Check the level of alignment and the stability of the machine with a spirit level. Adjust any
unevenness in the floor with the height-adjustable legs (1).
The optionally available roller conveyor module can be mounted using the illustration in 11.3.
5.3 Transport rollers
The mixer is equipped with two transport rollers on the bottom of the housing. These transport
rollers can be made to protrude out of the mixing compartment by turning a screw on each side of
the machine.
• Use a suitable tool size SW 17 to turn out the transport rollers on both sides of the machine.
•
The door must be opened for the machine to be handled safely during transport. Secure the
opened door with the hand against swinging
• Carefully tilt the mixer and move it.
When you are finished moving the machine, turn the transport rollers back.
5.4 Mains connection
Pay attention on proper protection of the electrical circuit such as described under 11.1 Only use
Type B residual-current devices (RCD).
Place the mains cable in a way to prevent from stumbling or snagging.
Transport rollers
Machine foot