TMX 1000 - 110 v US
Collomix GmbH
TMX 1500 - 240 v US
85080 Gaimersheim
Page 10
Rev. 5
Prior to commissioning
The machine must always be checked for damage prior to each commissioning.
Make sure that the machine is standing securely on a 昀椀rm and level surface. Risk of 琀椀pping!
Electrical installa琀椀on
Check that the voltage indicated on the type plate matches the available mains voltage.
Connect the mains plug of the machine to the power supply socket using a suitable extension
cord (type H07 RN-F, at least AWG 16). This socket must feature a residual current device (RCD).
Do not connect to standard electrical sockets.
Opening the lid
Pull the release knob with one hand and li昀琀 the lid at the same 琀椀me with the second hand. The
lid is locked when in open state. The release knob needs to be pulled again to close the lid.
Connec琀椀ng the vacuum cleaner
In order to signi昀椀cantly reduce the dust load when 昀椀lling the material and at the start of the
mixing process, we recommend connec琀椀ng a deduster to the hose supports (Ø 35 mm) of the
lid. The deduster used must comply with dust class “M”.
Mixing tool
Check whether the mixing tool is correctly mounted and fully seated on the sha昀琀.
If necessary, you can adjust the individual mixing paddles.
RCD 30mA
Moun琀椀ng the wheels:
Before you put the wheel on the relevant axle, one of the accompanying washers needs to be
inserted. Once this has been done, a琀琀ach the wheel and one further washer to conclude. Se
-
cure the wheels with the accompanying co琀琀ers as well.
A
