Product Manual
SDM09H-Hosereel Page 18
Issue 2
– April’20
4.5.6.8
Remove the nuts and shakeproof washers, which secure the bottom half of the bearing housing to
the top of the hosereel frame. Remove the old part and replace with the new component. Refit the
nuts and shakeproof washers and tighten.
4.5.6.9
Lower the drum into place, at the opposite end of the drum, refit the bolts securing the bearing to
the top of the hosereel frame, and tighten. Fit the new bearing housing top, refitting and tightening
the two bolts and shakeproof washers.
4.5.6.10
Refer to section 4.5.3 regarding replacement of the inlet seal (and the two types of seal that may
be fitted).
4.5.6.11
Apply a little grease to the mating parts of the seal and put the inlet in position, locating with the 3
bolts and shakeproof washers. If the spindle has the ‘O’ ring type seal, take care not to damage
the ‘O;’ ring when positioning the inlet.
4.5.6.12
Tighten the 3 bolts evenly until secure and reconnect the inlet hose to the inlet using thread sealant
as required.
4.5.6.13
If the hosereel has a chain drive, re-tension the chain by moving the motor mounting plate until
there is 13mm total side movement of the chain at the mid-point in its tightened position. Check the
tension of the chain over one complete revolution of the drum. Once this has been achieved,
tighten the 4-drive unit fixing bolts.
4.5.6.14
Refit the chain guard.
4.5.6.15
Check the reel turns freely when the hose is pulled out. If necessary, adjust the brake as described
in section 2.4.
4.5.6.16
Fit the rewind handle (or re-connect the rewind power supply) and check that the rewind operation
works correctly, ensuring the gears are correctly meshed and running smoothly and check for any
leaks in the fluid path.
