Product Manual
SDM09H-Hosereel Page 13
Issue 2
– April’20
3.3
Rewinding the hose
–with the hydraulic rewind motor
3.3.1
Observe the warnings and cautions under 3.2 above.
3.3.2
Return the nozzle to a position adjacent to the hosereel.
3.3.3
Make sure the manual rewind handle is not fitted and the brake is correctly set see section 2.4.
3.3.4
Operate the controls as directed by the installer of the hydraulic system and commence rewind of
the hose.
3.3.5
Allowing the hose to run freely between gloved hands, guide it evenly across the drum of the
hosereel.
3.3.6
When the hose is almost completely rewound, reduce the speed of rewind until all the hose has
been rewound onto the drum.
3.3.7
When all the hose has been rewound onto the drum, set the brake to prevent the hosereel drum
turning.
3.3.8
Finally, ensure that the nozzle is stored safely.
3.4
Operating ancillary devices
3.4.1
Fixed 4 way roller guides
The hose should be fed smoothly between the roller guides when deploying and rewinding. Care
must be taken not to trap hands between the rollers.
3.4.2
Hinged roller guides
Before deploying the hose, the roller guide(s) should be swung into the open position. After use,
and when the hose has been fully rewound, the rollers must be returned to the parked position
3.4.3
Top tilt out roller guides
3.4.3.1 To deploy the rollers first operate the latches at each end before pulling forward the rollers. In the
case of inverted hosereels a pull wire is provided to operate both levers simultaneously. Ensure the
levers return to the latched position before deploying the hose.
3.3.4.2
After rewinding of the hose return the rollers to the “parked” position by unlatching both levers prior
to pushing the rollers back. Ensure the levers return to the latched position.
CAUTION
Do not push the rollers to the parked position without first operating the levers, this may
cause irreparable damage.
3.4.4
Swing out platforms
The spring bolt should be released and the platform opened to the required position, securing with
the appropriate spring
bolt. After use the platform should be returned to the “parked” position and
secured with the spring bolt. Dependant upon the installation there may be additional instructions
which should be followed.
