ColleBuilt Products SD-70 Скачать руководство пользователя страница 1

ColleBuilt Systems Inc. 

12130 Dearborn Place 

Poway, CA 92064 

858-748-9414 

[email protected] 

 

ColleBuilt SD-70 Auxiliary Battery System 

Revised 9-6-16  

 

Thank you for purchasing a ColleBuilt Auxiliary Battery System! By installing this 
system, you are providing the main power source of the vehicle (the battery) with an 
auxiliary battery power source. The system uses the vehicles factory charging system 
and safely charges an auxiliary battery once the vehicle is started and adequate 
charging voltage is present. When there are no charging sources present (vehicle off or 
a charging system failure) the system will isolate the auxiliary battery to prevent vehicle 
loads from drawing power from it. Provided in the kit is a manual activation switch that 
can be used at the operators discretion to link the auxiliary battery into the system at 
any time. 

 

WARNING

 

Read  the  instruction  manual  provided with  the  products  and  install 
them following all guidelines. Follow the maintenance guidelines as 
instructed in the installation instructions as well as this notification 
form. If a back-up system is not properly installed into the modified 
vehicle  and  maintenance  guidelines  are  not  met,  it  could  result  in 
serious injury and/or death.  

  

 

INSTALLATION GUIDELINES 

 

1.  Failure to follow these guidelines will deem all applicable warranties null and 

void. 

 

2.  Failure to follow these guidelines may result in system failure which could result 

in serious injury and/or death.  

 

3.  All parts and/or components of the backup system must be installed in the 

locations designated herein these instructions. If a location is not designated than 
the parts or components must be installed and/or protected in such a way as to 
not be exposed to excessive heat, vibration, sharp edges, moving parts, or 
weather.  

 

4.  All electrical components including but not limited circuit breakers, relays, and 

switches must be installed inside the passenger compartment unless otherwise 
dictated herein these instructions.  

Содержание SD-70

Страница 1: ...rovided with the products and install them following all guidelines Follow the maintenance guidelines as instructed in the installation instructions as well as this notification form If a back up system is not properly installed into the modified vehicle and maintenance guidelines are not met it could result in serious injury and or death INSTALLATION GUIDELINES 1 Failure to follow these guideline...

Страница 2: ...battery All ground connections should be made directly to the vehicles negative battery post on the main battery All 12V connections should be tied directly to the vehicles positive battery post on the main battery All wiring for the solenoid and charging isolator 12V connections should be equivalent size gauge to the factory main battery wire or 4 gauge wire whichever is larger Also the chassis g...

Страница 3: ...ive battery post on auxiliary battery 16G Out to empty small terminal on solenoid opposite of the ground connection Blue Red Brown Orange 16G Chassis Ground Switch Wiring Solenoid 16G ground wire 4G Wire Minimum 4G Wire Minimum 4G Wire Minimum 4G Wire Minimum 5A Fuse within 18 Of Battery ...

Страница 4: ...and it is now time to check override switch function 4 Allow any surface charge to dissipate and using a voltmeter measure the voltage of each battery and record the results 5 With the key in the off position turn on the vehicles lights manually and using a volt meter monitor the main battery s voltage It should drop steadily as the load from the light circuit slowly drains power from the main bat...

Отзывы: