Coleman Powermate PW0924001, Технические характеристики

Страница: 2 / 12

Following is information concerning the five nozzles
provided with your pressure washer.
NOTE: The force of the spray on the surface you are
cleaning increases as you move closer to the surface.
0° High Pressure (Red): The water stream discharged is
very aggressive. Use with extreme caution to prevent damage
to the surface being cleaned or injury to persons or animals.
15° High Pressure (Yellow): This is the nozzle used for
most cleaning applications. It provides narrow coverage and a
highly powerful water stream.
25° High Pressure (Green): Use of this nozzle offers
both a medium coverage and water stream. Best used for
flushing dirt and debris off surfaces.
40° High Pressure (White): This nozzle is used for
cleaning with the widest coverage over a larger area with a
powerful water stream.
65° Low Pressure (Black): Provides low pressure spray
and a wide coverage. Used primarily when operating the
chemical injector to apply chemicals.
Replacing the Nozzles
To replace a nozzle with a different nozzle, an easy quick
connect has been added to the end of the wand. With the
handle in the locked close position and the wand pointing
away from the user. Pull back on the quick connect fitting and
pull out the nozzle and replace with desired nozzle.
The pump is shipped with a shipping plug. This will need
to be replaced with the vent plug that is supplied.
The pressure is adjustable by turning the pressure
adjustment knob located on the pump of the pressure washer.
The knob must be set at the extreme clockwise position for
maximum pressure and turned several turns counter clockwise
for maximum pressure.
NOTE: With the pressure adjustment knob turned to
the maximum pressure position (clockwise), the pump
pressure may exceed the rated pressure of the machine
which could over load the engine. Adjust the knob counter
clockwise to reduce the pressure and lower the power
requirements of your pressure washer pump.
The pressure may also be regulated by the use of the
engine speed.
2
Inlet Pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40 PSI
RPM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3400
GPM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.5
PSI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4000
Recommended Oil . . . . . . . . . . . . . . . . . . . .30W-Nondetergent
Oil Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 Ounces
Change oil after (HR) . . . . . . . . . . . . . . .Initially 50/Every 500
Consult the pump manufacturer for special requirements that
must be met if the pump is to operate beyond one or more of
the limits specified above.
PUMP SPECIFICATIONS
SPRAY NOZZLE SELECTION PUMP PREPARATION
PRESSURE ADJUSTMENT
English