Coleman BACKYARD SELECT 3 BURNER GRILL, Эксплуатация и обслуживание

Страница: 17 / 116

Description
Page 4
Figures : see pages 5 to 11
1 - Control knobs (3x)
2 - Electronic ignition button
3 - Shelves (2x)
4 - Thermometer 5 - Lid
6 - Cooking grills (3x)
7 - Simmering grill
Page 6
8 - Hooks for accessories
9 - Side shelves (2x)
10 - Doors (2x)
11 - Cooking grill (x3)
12 - Wind shield
13 - Grease deflector
14 - Grease flow guide
15 - Aluminium grease drip container 16 - Grease drip drawer
17 - Burner protection cap (x3)
18 - Wheels (x4)
19 - Simmering grill
20 - Storage shelf
21 - Match bracket
22 - Housing
23 - Control panel
17
GB
• Do not use charcoal or lava rock.
• Do not use an adjustable low pressure regulator.
• Do not cover the bottom of the base with aluminium foil.
• Do not cover or replace the burner protection caps with a metallic plate that is neither designed nor
recommended by COLEMAN®.
Follow these instructions carefully to avoid seriously damaging your barbecue.
Operation and maintenance
a) FOR YOUR SAFETY
- Do not store or use petrol and other flammable liquids or
vapours in the vicinity of this barbecue. If you smell gas:
1) Close the valve of the cylinder
2) Extinguish all naked flames
3) Open the lid
4) If the smell continues ,see “ g Checking for gas leaks”
or immediately seek advice from your local retailer.
b) LOCATION
- This barbecue must only be used outdoors.
- Caution: accessible parts may get very hot. Keep
young children away.
- There should be no combustible materials within a
radius of approximately 60 cm around the barbecue
- Do not move the barbecue when alight.
- The appliance should be operated on a level surface.
- Estimated air offtake 2 m
3
/kW/h.
c) ASSEMBLY
Unpacking (Figures: see page 5)
- Remove the doors at each end of the equipment and put
them to one side.
- Hold the sides of the box and lift it off. The equipment
should remain on the packing base.
Note: there are boxes inside the equipment.
- Remove boxes A and C located underneath the grill
(Figs. 1 and 2).
- Remove the two screws holding the left equipment
panel in place and remove it (Figs. 3 and 4). Put it to one
side.
- Remove the remaining boxes and the equipment lid
(Fig. 5).
- Reposition the left panel and retighten the two screws
(Fig. 6).
Wheels (Fig. 8)
- Place some cardboard from the packaging on the
ground to protect the equipment whilst you fit the
wheels.
- Lay the rear of the equipment on the ground on top of
the cardboard.
- Fit the wheels with brakes at the front of the equipment.
- Fit the other two wheels at the rear.
- Raise the equipment gently on its wheels.
Wind shield
- Remove the four screws marked V already in place (Fig.
9).
- Insert the wind shield onto the equipment and retighten
the four screws (Fig. 10).
Grease deflector
- Insert the deflector via the top (item 13 page 6) (Fig. 11).
Place it lengthways to the equipment (Figs. 12 and 13).
- Position the deflector tabs correctly in the slots provided
for this purpose (Fig. 13).
select grill 3B.qxp 23/01/2007 09:31 Page 17