Assembly
continued.
Step 6
■
Install post onto post base.
■
Decal on post should face front
of heater (see photo on front
cover).
■
Attach post to post base using four
large screws.
■
Tighten screws securely.
Step 7
Step 8
■
Load cover onto post.
■
Slide cover down.
4 Required
Large Screw
6
3 Required
Small Screw
Step 10
Step 9
■
Using the three screws removed in Step 8, securely attach clamp
assembly to support tubes.
■
Insert table supports into the receptors located in the underside of the
table frame.
NOTE: Screws must be backed out of the support tubes. Use those
screws to attach the clamp in the next step.
■
Load table onto post by sliding
table clamp over post and feed post
through center hole of table.
■
Slide table to desired position.
Step 11
■
Tighten clamp so table is secured to the post.
Friction Sleeve (between
clamp and post)
Gap in Sleeve should be
opposite gap in clamp
Support Tube
(For models without a table, skip to Step 12)
