Charging the battery
Note: Do not turn the charger on
before attaching the charger clips to
the battery terminals.
The standard charging rate is 0.7A x
5 -10 hours. Maximum charging rate
is 3A x 1hour
1. Attach the Charger to the battery
terminals. Red clip to the POS + side
of the battery. Black clip to the NEG -
side of the battery.
2. Plug in the charger and turn on
making sure it is set at the correct
settings.
3. Once battery is charged, unplug
the charger before disconnecting the
POS + and NEG- clips
CAUTION
Reversing the battery lead wires
can damage the charging system
and the battery.
The red lead (clip) must go to the
POS (+) side of the battery. The
black lead (clip) must go to the
NEG (-) side of the battery.
Installing the battery
1. Install battery in battery bracket
located under left rear fender of ATV.
2. Attach the red wire to the POS +
side of the battery with screws pro-
vided. Attach the black wire to the
NEG - side of the battery with screws
provided. Make sure the connections
are tight.
3. Install the rubber strap to hold
the battery in place.
WARNING
If not performed the correct way,
charging the battery could be
hazardous.
While charging battery, keep away
from sparks and open flames. The
battery gives off explosive gasses.
Always connect the charger to the
battery before turning the charger
on, this will prevent sparks when
attaching the terminal clips to the
battery.
Always unplug the charger before
disconnecting the battery from the
charger, this will prevent sparks
when removing the terminal clips
