8
Preparing the microscope for use
Carefully remove the items from its packaging and place them on a flat,
firm surface. Please do not expose the microscope to direct sun light, high
temperatures, damp, dust or acute shake. Make sure the table or surface is
flat and horizontal
When moving the microscope, use the left hand to hold the transport
handle and hold the base of the microscope with the right hand
Hold the microscope at the top of the stand arm when it needs be
moved. Holding the microscope by its stage or focusing knob will
damage the microscope
Caution!
If the bacterial solution or water splatters over the stage, objective
or head, please pull out the power cord immediately and dry the microscope
Assembling Steps
Mounting the objectives
1.
Rotate the coarse focusing knob to lower the stage to its lowest position
2.
Install the objectives into the objective nosepiece from the lowest magnification to the highest in a clockwise
direction from the rear side of the microscope. When using the microscope, start using the low magnification
objective (4x or 10x) to find the specimen and focus, then continue with a higher magnification objective to
observe in more detail
Placing the eyepieces
The 360° rotatable heads are equipped with WF10x eyepiece(s) (H). Please remove the screw before taking out the
eyepiece to prevent damage
1.
Remove the cover(s) of the eyepiece tube(s)
2.
Insert the eyepiece(s) into the eyepiece tube(s)
3.
Lock the eyepiece(s) with a hexagon screw
