Cold Jet i3 MICROCLEAN 2, Руководство пользователя

Страница: 29 / 64

23
Compressed Air Supply
For best results while blasting, incoming air supply must be as free of oil and dirt as possible.
It is recommended that the incoming supply air— filters, oil filters, and water separators are
continuously monitored to ensure the MicroClean 2 receives the air your machine use is specified
for. The compressed air must have a low moisture level for optimal and continued performance. It
is recommended that the moisture content of the supply air meet the minimum class 3, ISO 8573-1
at standard intermittent usage and class 2, ISO 8573-1 at continuant non-stop blasting.
Starting the i
3
MicroClean 2
WARNING Never blast the HMI screen area of the MicroClean 2 with dry ice as this will
cause permanent damage to the screen.
Follow these instructions to start the blasting job:
1. On the control panel, press the power button to turn the MicroClean 2 on.
Figure 6: Power Button ON Status
2. Purge the system:
Always purge the system with compressed air during start-up, after
breaks, and before loading dry ice. This will remove any accumulated
moisture, water, and ice in the system.
a. On the Precision applicator, press the air+ice button (II) to activate (green light
indicates ON and pressing the II button again will set the system to OFF).
b. Using the rotary encoder dial, navigate to the feed rate indicator on the home screen
and adjust it to the maximum setting.
c. On the applicator, pull the trigger and blast for 10 seconds.
d. Set the feed rate to its minimal setting.