SECTION
1
PRICING CHANGING INSTRUCTIONS
1.
Remove the acceptor from the changer and place
in an area free of dirt and foreig'1 material.
2.
The S75-9800B has one switch module with five rocker
switches located on the upper portion of the printed
circuit board. (Figure 1-1 ) (These switches correspond to
prices as follows: #1 =5C, #2=1 OC, #3=20C, #4=40C, and
#5=80C). When the top of the rocker switch is pushed in,
the switch is in the ON position. Vend price is set by
adding the value of all rocker switches in the ON
position. EXAMPLE: Switches #2 and #3 in the ON
position = 30C vend price.
3. The S75-9800A has four price select slide
switches
(2
black and
2
white) located on the
upper portion of the printed circuit board. These
switches are
ON
when in the up position. (Refer
to figure
1-2 )
Set the vend price
by
sliding sufficient price
select slide switches into the UP position to total
the desired price. Example:
1
OC and 40C in the up
position= 50C.
4.
Vend price 25C and under. The 575-98008 is wired to
accept quarters when the payout tubes are empty. lf you
do not want to accept quarters when the payout tubes
are empty, remove the back coverplate and disconnect
the white wire from the piggy-back terminal on the
Common (red wire) of the tube empty switch. Reconnect
this wire to the center, Normally Open, terminal of the
same switch. (Figure 1-3) The quarter C.R.E.M. will now
de-energize when the nickel payout tube is empty.
5. Replace the back coverplate.
3
Figure 1-1: S75-98008
I
Figure 1-2.' S75-9800A
-- --,
"Ii
Figure 1-3
-
