6.0 Connect Camera
1. For the 7520
HD
series cameras attach the supplied ferrite clamp to the Ethernet cable, and connect the
cable to the Ethernet connector port in the camera as shown in Figure 5.1.
2. Route and connect the optional (not supplied) audio cable when using an external microphone and pow-
ered loudspeaker (not supplied) to the 7520
HD
dome camera as shown in Figure 5.3. The external micro-
phone and powered loud-speaker (not supplied) will connect to 3.5 mm audio connectors.
7.0 Camera Positioning, Field-of-View, Set-up and Focus
1. Set the field-of-view using the 3-axis gimbal. Determine camera pan direction by gripping the camera as
-
sembly, and carefully pivot the camera to the viewing direction.
2. Adjust the tilt of the camera by loosening the tilt angle lock screws as shown in Figure 6.1, and tilt the
camera to the viewing direction. When finished, tighten the tilt locking screws.
3. Adjust the field-of-view and focus rings to achieve the desired focus as shown in Figure 6.2.
NOTE:
The lens on the 7520
HD
dome camera is fixed iris and therefore no iris adjustment is needed.
When finished, tighten the thumbscrews on the lens.
Figure 5.1
Optional audio
In/out cable assembly
Audio cable can only pass through
the conduit entry
Focus Control
Zoom Control
Figure 6.1
Figure 6.2
11
6X-1102C
