12
telnet
Figure 6 - Configuration example
telnet, setting the desired end-of-line format
When using telnet to exchange with the
CPRR radar, it is required to set the line end
format
<CR> <LF>
.
To do this, enter the telnet menu by pressing
Ctrl + ]
and enter the command:
set crlf
, as
shown in the figure.
Configuring the IP address of the radar
To change the IP address of the radar, enter the following commands:
config ip 192.168.1.4
save
Note: the change of the IP address will occur only after the radar reboot.
An example of changing the IP address is shown in the figure below:
Figure 7 - Example of configuring the IP address of the radar
www.cognitivepilot.com I
I User Manual Radar CPRR
07.2021
