Coffing Hoists EC Series, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 9 / 48

9
P/N EC680-7 April 2017
Order # 5041558-0 & 5041679-0
2-8. CHAIN CONTAINER INSTALLATION
a. Operate hoist in “down” direction until it is stopped by the limit
switch. Disconnect the slack end of the chain from the hoist
by using a small screwdriver to slide the spring-load pin to the
left. At least 8 inches of chain should hang from the hoist. If
less than 8 inches of slack chain is present, readjust lower limit
switch using the procedures detailed in paragraph 5-2.
b. Slide the spring-loaded pin aside and slip the mounting arm
into the slot until the pin fits through the hole in the plate (see
Figure 2-2). Be sure pin passes completely through plate and
into the opposite housing.
c. Use the two hex washer head screws provided to fasten the
two remaining hanger chains into the notches on the lower
edges of the hoist housing.
d. Be sure the end of the chain is started into the container. Run
hoist up until the hook block is even with the bottom of the
chain container.
e. Reset upper limit switch at this position (see procedure,
paragraph 5-2) to prevent the possibility of raising a load into
the chain container.
5
Country Club Road
P.O. Box 779
Wadesboro, NC 28170 USA
TEL: (800) 477-5003
FAX: (800) 374-6853
Hex Head
Washer Screw
Slot For
Small Screwdriver
Mounting Arm
Spring Loaded Pin
Chain Container
CAUTION
Short edge of chain container
body must be mounted toward
hoist (as shown).
FIGURE 2-2. LUG-MOUNTED PLAIN TROLLEYS
5
Country Club Road
P.O. Box 779
Wadesboro, NC 28170 USA
TEL: (800) 477-5003
FAX: (800) 374-6853
Hex Head
Washer Screw
Slot For
Small Screwdriver
Mounting Arm
Spring Loaded Pin
Chain Container
CAUTION
Short edge of chain container
body must be mounted toward
hoist (as shown).
FIGURE 2-3. CHAIN CONTAINER