Coffee Queen Bean to cup hot & cold TT, Руководство по обслуживанию

Страница: 8 / 44

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
8
.
ON / OFF
Switch
4. Service. Installation and start Bean to cup hot n cold TT
1. Place the brewer on a flat
level and waterproof surface.
Connect the electrical plug to a separate
grounded wall socket
OBSERVE!
Make sure there is a space
behind the machine
for free flow of air.
( minimum 10cm ).
2. Connect attached water tube to cold water with an R 1/2”.
Make sure that the water hose not are kinked anywhere when machine is
pushed into place.
Please flush the water tube before connecting to machine, this to avoid
any particles to damage the inlet valve.
3. Open the water inlet.
4. Turn on the ON-OFF switch inside the door.
Water is been filled into the tank automatically with
2,4 litres of water. The heating will not start before
the water level reaches the level sensor.
Set temperature is approx 97ºC.
5. Close door.
6. When the water is heated to right temperature. ”please wait”
The message ”please wait” will disappear.
NOTE! Machine must be heated before chilled water can be in use.
7. Push button for chilled water until water is coming in a even flow.
8. Wait for approximately 10 minutes then machine is
ready to use.
(IThis for water shall getting cold).
”Please wait”