29
English
MESSAGE CODE
DESCRIPTION
DTER
DATA Error
The initial configuration settings are fautly or have been loaded incorrectly. The projector has loaded its default
configuration. Turn the projector off and on again and if the error persists the EEPROM is either defective or
absent; refer to your
Coemar
service centre for a replacement component.
ADER
DMX ADDRESS Error
The projector is not receiving all the DMX channels necessary for its operation. Check the DMX address and the
control console operation. Note that some controllers may not generate all 512 channels of signal.
MAER
MASTER MODE Error
This message indicates that the user has attempted to set the unit to MASTER mode whilst DMX signal is still
being received. Detach any DMX control signal or remove MASTER mode settings.
8.8. Error messages
ATTENTION!!
always remove mains power prior to opening the fixture !
10. Maintenance
9. Spare parts
Fuse A:
6,3A F 250V
Fuse B:
2,5A F 250V
10.1. Fuse replacement
Use a multimeter to check the fuse, replacing any faulty or damaged fuses with ones of equal value, dimensions and characteristics.
The following diagram indicates the positioning and characteristics of the protection fuse in the fixture.
Whilst every possible precaution has been taken to ensure the trouble-free operation of your
Stage Lite Led
, the following periodic
maintenance is higly recommended. We also recommend that the voltage to the unit be removed prior to any maintenance procdure
taking place..
All the components of
Stage lite led
are available as spare parts from your
Coemar
. Accurate description of the fixture, model num-
ber, and type will assist us in providing for your requirements in an efficent and effective manner..