Coemar Par Lite LED White, Инструкция по эксплуатации

Страница: 11 / 18

Par Lite Led White
can operate in three modes:
1.
using DMX512 control signal
2.
automated “STAND ALONE” or “MASTER/SLAVE” modes (see chapter 9. AUTO function )
6.1. Connecting DMX signal
Control signal is digital and is transmitted via two pair screened cable, as recommended in international standards for the transmission
of DMX512. Connection is serial, utilising the XLR3 sockets located on the rear panel of the Par Lite Led White.
Signal connection via the XLR3connectors
Connection is to international standards. Connection is as indicated below:
pin 1 = GND
pin 2 = data -
pin 3 = data +
Should your DMX 512 controller output signal via a cannon XLR5 (5 pin), pins 4 and 5 should remain unconnected.
6.2. Powering up
After having followed the preceding steps, turn on mains power on to the unit.
The
POWER
led located near the dip-switch panel will come on.
Turning on power with DMX signal connected.
The yellow DMX led will flash to indicate that DMX 512 is being correctly received. If the yellow led is off, DMX signal is not being
received (see section 15. Frequently asked questions ).
ATTENTION!!
Ensure that all data conductors are isolated from one another, the screening and the metal housing of the connector.
Pin number 1 and the housing should never be connected to mains power.
6. DMX signal functions
11
English