Coemar Panorama Cyc 250 C., Инструкция по эксплуатации, Страница: 7 / 29

The fixture may operate at voltages ranging from 100-115-208, 230 or 240V .at 50 or 60 Hz; coemar factory presets (barring spe-
cific requests), a voltage of 230v and a frequency of 50 Hz. This preset is indicated on the sticker located on the base of the projec-
tor, as indicated in the following diagram.
If the specified voltage and frequency do not match those of the country in which you are operating, follow the instructions in sec-
tion 19 of this manual. “Altering the operating voltage and frequency”
Incorrect voltage and frequency selection will detrimentally affect the operation of the projector.
Due to its high protection rating Panorama Cyc 250 C may be installed in a variety of locations, both indoors and in areas expo-
sed to the elements.
7.1 Installing the unit in weather protected areas.
Panorama Cyc 250 C. may be situated in any mounting position when operated in sheltered areas.
In order to allow it to be installed in a variety of locations, the Panorama Cyc 250 is provided with 5 mounting holes (A) of Ø 13mm
on its base; for permanent and secure mounting on any surface.
If hanging the unit from ceiling or a structure, you may utilise the holes (A) which allow for the attachment of a “c” clamp at any posi-
tion through 360°. The structure from which the unit is hung should be of sufficient rating to hold the weight of the unit, as should
any clamps used to hand the unit.
7.2 Installing the unit in exposed areas
The Panorama Cyc 250 C may be situated in several mounting positions when installed in an exposed area, thanks to its IP 44
protection rating. To ensure proper installation, however, there is a simple guideline to follow:
Installing the unit incorrectly may cause damage to occur and will immediately void the warranty.
Attention!
As shown in the diagram, base of the unit must always be facing the ground.
The Panorama C yc 250 C may be adjusted from -45° to +90°.without having to move any other component except the head
of the fixture.. Installation in any position other than with the base down, will cause the projector to not perform with its maximum
protection rating, although, with adequate covering, it may operate in almost any position.
175mm
6,90”
120mm
4,72”
= =
325mm
12,80”
7. Installation
factory set
main at:
100V
115V
208V
230V
240V
50Hz
60Hz
6. Operating voltage and frequency
7
English