Each
Panorama Cyc 250 C
utilises
4 channels of DMX signal for complete control of all its functions.
To ensure that each unit accesses the correct signal, it is necessary to correctly address each fixture. Any number between 1 and 508
can be generated via the dip-switches of the
Panorama Cyc 250 C.
.
This procedure must be carried out on every unit being utilised, positioning the dip-switches to either
ON
or
OFF
depending upon
what
DMX
address is required.
The
DMX
address of a particular projector is the sum total of the dip-switches settings, for example:
DMX 42
is obtained by switching the dip-switches values
32+8+2
to
ON
DMX 82
is obtained by switching the dip-switches values
64+16+2
to
ON
The diagram below shows how to set the dip switches to their
ON
position, setting the address to
DMX 1
.Obviously, any
DMX
address can be achieved by adding together the values achieved when switching on the respective dip switches.
es. dmx address n° 1
The first projector will utilise
DMX
address 1; a projector thus addressed will respond to commands on channels
1
to
4
from the
DMX 512
controller. A second projector should be addressed as
5
a third as
9
and so on until the final unit has been addressed.
Ensure that none of the
DMX
values you assign overlap. This will ensure that each projector can have all its functions individually
addressed by the console.
To learn further about the individual operation of each function of the
Panorama Cyc 250 C
, refer to section 12 of this
manual
“Operating via DMX 512 signal
”.
ON
dip-switches
1
2
4
8
16
32
64
128
256
11. DMX addressing
12
English
Содержание Panorama Cyc 250 C.
Страница 1: ...1st edition may 2002 instructions manual ...