Coemar F026G000A, Инструкция по эксплуатации, Страница: 15 / 31

15
Warning!!
If you alter the DMX address with no DMX signal connected, the digits on the display panel
will continue to flash even after you have pressed ENTER button to confirm the address.
A00 1
7.
Turning on the projector
After having followed the preceding steps described, proceed with the power supply and turn on
the projector connecting it to the mains power.
The software version installed on the internal microprocessors will be shown on the display, sud-
denly it will show the current DMX addressing. If the address blinks, it means that the DMX signal
has not been received. Check the connection cable and the mixer functioning.
7.1
DMX address of the unit
Each projector can use 6, 2 or 1 address channels for its complete operation and is controlled
by a DMX 512 signal.
DMX addressing
When powered up initially, each projector will show A001, which indicates DMX address 001;
for example, when set at 6 channels a projector thus addressed will respond to commands of
channel 1 to 6 from your DMX 512 controller . A second unit must be addressed as A007, a third
one as A013 and so on. The operation must be carried out on every
Softlite Led VariWhite
which has an address different from A001.
Altering the DMX address:
1.
Press the + or – button until the display shows the required DMX address. The digits on the
display will blink to indicate that the variation has not been registered.
2. Press the enter key to confirm your selection. The digits on the display panel will cease to
blink and the projector will now respond to the new address.
Note:
by holding the + or – button down the scrolling will be faster; thus allowing a faster se -
lection