Using Your Remote Transmitter
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK icon button
on the transmitter. The horn will honk twice and the parking lights will flash twice,
indicating the system is armed. The doors will also lock at this time (if equipped and
connected). The blue dashboard status indicator light will blink steadily, once per
second. To arm the system silently, press and hold the LOCK icon button for 2
seconds. The parking lights will flash 2 times, indicating the system is armed and
has locked the doors (if equipped and connected). The blue dash mounted status
indicator light will blink steadily, once per second.
Pre-arm Mode
If the horn honks and the parking lights flash only once, this indicates that the vehicle’s interior light is
on or an entrance is left open. Check to see that all doors hood and trunk are closed properly. Once all
entrances are secured (and the interior light is off), the system will honk/flash again. The system is
now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the
unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system, press the UNLOCK icon button. The horn will chirp, the parking lights will flash
once, and the doors will unlock (if equipped and connected). To disarm the system silently, press and
hold the UNLOCK icon button for 2 seconds. The parking lights will flash, indicating the system is
disarmed and the doors will lock (if equipped and connected).
Disabling/Enabling Confirmation Chirps
1. Turn the ignition key ON then OFF.
2. Within 10 seconds push and release the valet/override button 3 times.
3. The horn will honk 2 times to disable horn honks or 1 time to enable horn honks.
.
Attempted Intrusion Identification
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If
an intrusion attempt occurred, the horn will honk 4 times and the parking lights will flash 3 times when
disarming the system. Enter the vehicle an observe the dash mounted status indicator light to identify
which zone was triggered.
1.
IT-s Interior Theft Sensor- 1 flash, pause 1 flash, etc.
2.
Hood or Trunk Pinswitch- 2 flashes, pause 2 flashes, etc.
3.
Door Entry- 3 flashes, pause 3 flashes, etc.
The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition
key is turned on.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second.
3
Содержание CA-150
Страница 9: ......