Code 3 Thin WingMan MATRIX Series, Инструкция по установке и эксплуатации

Страница: 3 / 16

Page 3 of 8
Wiring Instructions:
IMPORTANT! This unit is a safety device and it must be connected to its own separate, fused power point to assure its continued operation
should any other electrical accessory fail. Do not wire in parallel with any other accessory.
Notes:
• Larger wires and tight connections will provide longer service life for components. For high current wires it is highly recommended
that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do not use insulation displace -
ment connectors (e.g., 3M Scotchlock type connectors).
• Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to reduce volt -
age drop. High ambient temperatures (e.g., under-hood) will significantly reduce the current carrying capacity of wires, fuses, and
circuit breakers. All wiring should conform to the minimum wire size and other recommendations of the manufacturer and be pro -
tected from moving parts and hot surfaces. Looms, grommets, cable ties, and similar installation hardware should be used to anchor
and protect all wiring.
• Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to protect the wiring
and devices.
• Particular attention should be paid to the location and method of making electrical connections and splices to protect these points
from corrosion and loss of conductivity.
• Ground termination should only be made to substantial chassis components, preferably directly to the vehicle battery.
• Circuit breakers are very sensitive to high temperatures and will “false trip” when mounted in hot environments or operated close to
their capacity.
Caution:
Disconnect the battery before wiring up the product, to prevent accidental shorting, arcing and/or electrical shock.
Connect the red (power) and black (ground) wires from the Matrix
®
enabled Thin WingMan to a nominal 12-24 VDC supply, along with a
customer supplied in-line, 10A slow blow ATC style fuse. Please note that the fuse holder selected by the customer must also be rated
by its manufacturer to meet or exceed the corresponding fuse ampacity.
See Figure 1 for details.
The Matrix
®
enabled Thin WingMan must also connect back to a central node, such as the Serial Interface Box or Z3 Serial Siren, to
establish serial communication with the larger network. Please note, for CAT5 connections the PRI-1 port must always be utilized first, before
additional devices can be connected to the SEC-2 port. See Figure 1 for details.
Figure 1
BLACK
10A
BLACK
10A
RED
RED
Matrix
®
enabled
Thin Wingman
Matrix
®
enabled
Thin SuperVisor
CENTRAL NODE
PRI-1 SEC-2 B Y