Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email:
www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual
January 2006
Figure 15
Basic Cold-Mount
®
Procedure
Using an adhesive coated board,
peel the release liner back about
1-½” from the top of the substrate,
then fold and put a sharp crease
in the release liner.
Figure 13
Figure 14
Line the print up with the edges of the
substrate. Lightly tack print along top
½” of substrate, working from the
center out or from one side to the
other, so as not to trap air. (Do NOT
press along the crease in the release
liner.)
Insert the tacked end of print about ½”
into the laminator. (Do not catch
release liner in the laminator.) As you
start the laminator, hold the print at a
45 degree angle above the top roller.
