EN
G
LI
S
H
10
17
18
D C
B
A
7
Assembly
Handle
1. Push the ends of the lower handle (18)
towards the brackets (A) on the back
of the mower. Make sure to put
the bracket pin (B) in the round hole
down on the end of the handle.
2. Push the coach bolt (C) into the square
hole (D) from the inside and screw on
the locking knob (17) from the outside.
Important
Make sure that
the electrical cable (7) is
lying along the outside
of the lower handle.
3. Place the ends of the upper handle
along the sides of the lower handle.
If you apply slight pressure this makes
it easier to press the ends outwards.
Important
The electric cable and control switch
should be on the right-hand side of
the mower.
4. Push the threaded end of the quick-
release clamp (3) through the hole from
the outer side of the handle and screw
it onto the nut.
Note:
Turn the nut
so that its concave seat mates with
the tube of the handle.