STEP I. INSTALL BATTERIES
1. Remove the
A
thumbscrews from both sides
of the battery case.
2. Remove the bottom panel from the battery
case (Figure 1).
3. Install four (4) “C” sized batteries
(not included).
4. Replace the bottom panel into the battery
case
5. Making sure the bottom panel and battery
case holes are aligned, screw in the two
A
thumbscrews into both sides of the battery
case.
STEP II. MOUNT THE LAMP ONTO YOUR PIANO
BOARD (Figure 2).
1. Loosen the thumbscrews from the top of the
battery case; do not remove completely.
2. Pull the front panel outward completely and
carefully place the mounting clamp onto your
piano board, making adjustments as necessary.
The front panel should mount onto the piano
board snugly.
3. Secure the lamp onto the piano board by
tightening the thumbscrews.
STEP III. LIGHT CONTROL: THE ON/OFF TOGGLE
SWITCH IS PRE-INSTALLED ON THE LAMP SHADE.
SIMPLY TOGGLE THE TOGGLE SWITCH TO TURN
THE LAMP ON OR OFF (Figure 3).
STEP IV. ADJUST THE SHADE TO THE DESIRED
LIGHT ANGLE.
thumbscrew
(Figure 1)
(Figure 3)
(Figure 2)
A
COCOWEB.COM, INC.
42 Corporate Park, Suite 250
Irvine, CA 92606
Phone: 1-888-783-0378
co
co
web
TM
www.cocoweb.com
LAMP USAGE
COPYRIGHT © COCOWEB.COM, INC. 2014
The information contained in this document is subject to change without notice.
