Cocoon HE414114, Инструкция по эксплуатации

Страница: 10 / 16

6
After Sales Support
1300 663 907
Model Number HE414114
customercare@winplus.com.au
2. Installing Your Doorbell
a. Using the mounting bracket as a template, mark out where your Doorbell will be
installed.
b. Drill a hole through the wall in between the marked areas big enough to pass the
connector cable through. Ensure there is no wiring or pipes in or behind the wall.
c. Place the mounting bracket against the wall and pass the Doorbell wiring
through the hole.
d. Remove the screw covers in the top and bottom of the front of the Doorbell and
place the Doorbell, mounting bracket and Doorbell seal in the desired location.
e. Drill holes in the previously marked
positions, to the required depth, ensuring
there are no wires or pipes in or behind the
wall.
f. Insert the screw plugs into the drilled holes.
Secure the Doorbell and the mounting plate
using the screws provided.
g. Once secured, replace the screw covers to
shield the screw from sight.
3. Installing Your Handset
a. Using the mounting slots on the back of the Handset base as a guide, measure
and mark the desired location for your Handset.
b. Drill holes in the marked positions, to the required depth, ensuring there are no
wires or pipes in or behind the wall. Screws should remain slightly raised from
the wall as your handset will sit on these screws. Ideally, your handset should sit
flush with the wall.
c. Insert the screw plugs into the drilled holes and screw in the screws.
d. Run wiring along the desired route from your Handset to your Doorbell.
The cable may need to be secured depending on location.
e. Connect your Handset to your Doorbell using the 4 pin connector on your cable.
90m
m
1
2
3
4
A