Cocoon FPV HD Camera Drone, Инструкция по эксплуатации

Страница: 20 / 28

20
After Sales Support
Model Number
HE180101
customercare@winplus.com.au 1300 663 907
Operation
3.5 Level Calibration
This feature allows you to calibrate the drone so that it does not start to tilt during flight.
Calibration should only be done before flight not during flight. To calibrate the drone:
a.
Place the drone on a level surface
b.
Press the left and right thumb sticks to the lower right corners and
hold for 2-3 seconds. You will notice the drone LED lights will flash
c.
The level calibration will now be complete
3.6 Speed Control
The Cocoon FPV HD Camera Drone can be operated in a low and a high-speed setting. When you
turn on the drone, it will automatically be set to low speed. To change to high speed, depress the
right thumb stick in towards its centre, you will hear two beeps. If you are in high speed and want
to move to low speed, depress the right thumb stick again, you will hear one beep.
NOTE:
• You can adjust speed settings while the drone is in flight or while the drone is on the ground and
paired
• The drone’s default setting is low speed. If you change the speed to high and switch OFF the drone, it
will default back to low when you go to turn the drone back ON at a later time. If you however land
the drone without turning the drone OFF, then the drone will still be in high speed
3.7 360° Flip Stunt Feature
Once you are familiar with the basic flight operations, you can explore
the 360° flip stunt feature.
a. Fly the drone to a height of more than 3 metres
b. Press the upper right corner button on the remote control and
simultaneously push the right thumb stick in any direction to
perform the 360-degree flip
NOTE:
• Fully charge the battery before attempting the 360-degree flip. If
the battery power is low, the drone will not be able to perform the
360-degree flip
• Make sure you allow enough space both above and below your
drone before attempting to perform flips
• Never attempt tricks with bent or damaged propellers or guards
3m