Coccolle Siyana, Руководство пользователя

Страница: 32 / 39

EN
6.3. Insert the buckle tongue (part no.12 page01) into the vehicle buckle (part
no.13), and hear a "click". (fig. 28).
6.2. Then Extend the vehicle belt longer enough, Insert it from the slot at the
front of the seat, then through it into the slot to the other side. (fig. 27).
6.6.Then pull the diagonal belt at the top of the seat as arrow indicate. As tight
as
Finally check the child seat is fix stable on the vehicle seat. If you find any shake
that you must tighten the belt again until the child seat is tight enough.
7.1. Relax the harness before adjust the height, one hand press down the center
adjuster (part no.1O page 01), at the same time the other hand hold the
shoulder belt (part no.03 page 01) and pull back. (fig.31).
7.3. Put your child on the child seat, let the buckle (part no.22 page 01) is on the
front of your child's crotch. Make your child's arms through the should belt (part
no.03 page 01), the shoulder belt and the shoulder pad just on the top of your
child's shoulder. (fig 33).
Adjust the harness and headrest height refer to (chapter 4.4). The top of the
shoulder belt must be parallel or a little higher than the child's shoulders. Too
high or too low is not suggested. (fig 33).
6.5.Pull the diagonal belt at the top of the vehicle buckle make the belt tight. (fig.
30).
6.7 Installation of child: Refer the (section 7) to fix your child carefully to finish
the installation.
lmpor tant: Misuse the child car seat will reduce the protect that the seat
provides.
6.4.1nsert the diagonal belt into the slot at the rear or Ambra (part no.19 page
01). (fig. 29).
7.4. Reassemble buckle (part no.22 page 01) until you hear a "click". (fig.34).
you can. (fig. 30).
7.5. Pull back the adjust belt (part no.07 page 01) make the harness tight. To be
ensure
Check the belt at the right position and is tight enough at all of the position, and
no twist is present.
7.2. Relax the buckle: push down the release button on the buckle (part no.23
page 01), the buckle tongue will jump out. then put the harness to the both side
of seat. (fig 32).
Notice: If the harness is too tight, please relax it then adjust it again.
7. Securing the child
6. Installation in vehicle
6.1. Seat installation: Place the child seat to the rear seat in the vehicle, Let the
bottom of the seat against vehicle seat surface, and the front of the seat touched
vehicle seat backrest. (fig.26)
When your child's weight is between 0-13kg.lt need to fix your child by the 3-
point harness. According the follow step :
there should not be more than a fingers width between the harness and your
child. It's most importance of ensuring that any lap strap is worn low down, so
that the pelvis is firmly engaged, shall be stressed. (fig.35).