Fig. 3
Fig. 4
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum dimensions
(520 mm long,
∅
50 – 250 mm). Ensure also that the logs are
cut straight and square.
Place the log properly on the log splitter, so as not to cause
any risk of stumbling or falling to the operator.
Bleeding
Open the bleed screw 3 – 4 complete turns – Fig. 5.
Close the bleed screw again when you are finished splitting
logs.
Fig. 5
Bleed screw
tighten
open (bleeding)
Splitting logs:
¾
Always place the logs lengthwise and flat on the main
frame of the log splitter. The log must be enclosed by the
log guide plates. Fig. 6
Fig. 6
¾
Never place the log on the frame at an angle. Fig. 7
Fig. 7
¾
Always ensure that the splitting wedge and the log ram
contact the ends of the log at right-angles.
¾
Never try to split two logs at once.
¾
Never try to remove or replace the log during the splitting
process.
5
