Wall Mounting Instructions
The following steps enable installation on a new or existing telephone wall-
mounting plate or directly onto a wall.
(Your Cobra
Intenna
is designed to be
used with any AT & T, GTE, local phone company or other wall-mounting
plates that can be purchased from most local electronics stores.)
•
Run telephone cord through cord wrap channel on bottom of base. (As shown).
•
Plug modular phone connector into telephone wall jack.
•
Align mounting studs on the plate to the holes on the bottom of the
Intenna
base; push base onto studs and slide down on the wall plate.
•
Attach the power adapter to the POWER connection (on the base of the
phone) and plug into a household AC power outlet.
•
To install directly on any wall, you’ll need to provide two screws and wall
anchors; follow these steps:
— Drill two holes 3
1
/
4
" apart and insert the wall anchors.
— Drive the screws into the anchors until the head of each screw is
protruding about 1/8" from the wall.
— Align the holes in the cordless base over the screw heads; push base
in and slide down on screws (see diagram #3).
— Plug modular phone connector into telephone wall jack; attach the
power adapter to the POWER connection (on the base of the phone)
and plug into to a household AC power outlet.
7
Mounting Studs
Modular Phone Jack
Diagram #2:
Installation on a
telephone wall-
mounting plate
Diagram #3:
Installation
directly on a wall
Modular Phone Jack
Screw Heads
2505.MANUAL.pm
11/7/97, 11:43 AM
8
