Quick Set-Up Guide
The following basic steps enable quick and easy installation of your new
Cobra
Intenna
Cordless Phone for use on a desk or countertop. You are
encouraged to review this complete instruction manual to become familiar
with all of the operating instructions and features of your new phone.
NOTE: Before using, connect your new system to AC power (see instruc-
tions below) to charge it overnight (at least 12 hours) for optimum condi-
tioning of the rechargeable battery inside the cordless handset.
1
Insert round connector of power adapter into POWER jack (at rear of
cordless phone’s base; see diagram #1 below). Plug power adapter into a
standard 120 VAC household electrical outlet. Then place handset in
base so CHARGE indicator lights (see p. 12).
2
After charging, remove the twist-tie from the phone cord and plug the
modular telephone connector into the phone jack on your wall (see above).
3
Make sure that the RINGER switch is ON (located on base; see p. 11 for
details).
4
Set the PULSE/TONE switch (at the rear of
the base) for proper operation (see page 11
for details).
Note:
Make sure you have charged handset
in base 12 hours before using.
5
Install the 9V battery for Power Protector™
operation in the base as shown in the
illustration.
OFF ON P T
RINGER
PULSE/
TONE
POWER
9V DC
6
HANDSET
PULSE/TONE
SWITCH
Diagram #1
Connecting
power and
telephone
BASE UNIT—
REAR VIEW
ON/OFF
RINGER SWITCH
➂
4
DC POWER JACK
①
2
MODULAR
PHONE JACK
ELECTRICAL
OUTLET
9V
ADAPTER
2505.MANUAL.pm
11/7/97, 11:43 AM
7
