6
STEP 4 Tow Bar and Axle Assembly
Parts and Hardware Required:
Part# Description Quantity
9
Tow bar
1
8
Axle
1
Note:
The yoke (20) has been attached to the tow bar (9) with two screws M8x20 (4), small flat washer (5) and hex nut (6).
The control lever (18) has been attached to the tow bar using spring (19) and two screws M8x90 (22), flat washer M8
(5) and hex nut M8 (6). Bolt (21) has been attached to the tow bar using a quick release pin 4mm (23). Refer to parts
list on page 3 for replacement of
control lever (18), spring (19), yoke (20) and/or bolt (21).
Locate the tow bar (9) in the central notch of the undercarriage supports (2, 3) so the dump bed
release lever is facing down and the axle, when installed, will pass through the pivot hole in the end
of the tow bar. Slide the axle (8) through the undercarriage supports (2, 3) and the pivot hole in tow bar (9)
(
Fig. 3).
9
Fig. 3
