•
The voltage indicated on the rating plate must correspond to the voltage of the
power source.
•
Only use or replace power supply cables for this unit which correspond to the
types indicated by the manufacturer. See the operating instructions for the order
no. and types.
•
Never touch the mains plug with wet hands.
•
Do not run over, crush or pull the power supply cable or extension lead, otherwise
it may be damaged. Protect the cable from heat, oil and sharp edges.
•
The extension lead must have a cross section in accordance with the operating
instructions and be protected against splashed water. The connection must not be
in water.
Personal safety
•
Stay alert, watch what you are doing and use common sense when operating the
machine. Do not use the machine while you are tired or under the influence of
drugs, alcohol or medication.
•
Use personal protective equipment. Always wear eye protection.
Protective
equipment such as dust mask, non-skid safety shoes or hearing protection used for
appropriate conditions will reduce personal injuries.
•
Prevent unintentional starting. Ensure the switch is in the off-position before
connecting to power source and/or battery pack, picking up or carrying the tool.
•
Do not carry the machine with your finger on the switch
.
•
Remove any adjusting key or wrench before turning the machine on.
A wrench or a
key left attached to a rotating part of the machine may result in personal injury.
•
Do not overreach. Keep proper footing and balance at all times.
•
Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing
and gloves away from moving parts.
Loose clothes, jewellery or long hair can be
caught
in moving parts.
•
Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
•
The blades continue to rotate for a few seconds after the machine is switched off.
•
The machine is double insulated for safety and requires no earth connection. The
operating voltage is 230V AC, 50Hz (for non-EU countries 220V, 240V as
applicable). If you want to use an extension cable when operating your product,
only the following cable dimensions should be used:
•
–1.0mm2: max. length 40m
•
–1.5 mm2: max. length 60m
•
–2.5 mm2: max. length 100m
•
Note: If an extension cable is used it must be earthed and connected through the
plug to the earth cable of your supply network in accordance with prescribed
safety regulations.
•
If in doubt contact a qualified electrician or the nearest Cobra Service Centre.
•
WARNING! Inadequate extension cables can be dangerous. Extension cable, plug
and socket must be of watertight construction and intended for outdoor use.
•
It is recommended for increased electrical safety to use a Residual Current Device
(RCD) with a tripping current of not more than 30mA. Always check your RCD
every time you use it.
