11
10
OPERATION
TO TALK/TO RECEIVE
TO TALK
To talk hold the FRS 200 mic about 2
inches from your mouth. (Be sure to turn
the volume down before you hold the
speaker up to your ear.)
Push the PTT button on the side.
Speak into the microphone in a normal
voice.
When you finish your communication
release the PTT button.
You can communicate with everyone
who has a radio set to your channel.
There is no limitation to the number of
people you can talk to.
The TX will be displayed during
transmissions.
TO RECEIVE A CALL
To receive incoming transmissions
release the PTT button. Your FRS 200 is
always ready to receive
communications when the PTT button
is released.
**Note: While the PTT button is
depressed, you cannot receive
incoming transmissions. The BUSY
icon is displayed when the radio is
receiving an incoming communication.
TO CALL/RING
Push and hold the CALL button until
a confirmation tone is heard.
The CALL icon appears briefly.
This will send a call signal to other
Cobra FRS-200 units on the same
channel within calling range. If you
do not believe your call was
received, wait 10 seconds and call
again. The other units may not be in
Battery Save mode.
TO RECEIVE A CALL
Your FRS 200 must be in BATTERY
SAVE mode before you can receive
a call.
* To place your unit in BATTERY
SAVE mode, do not push any
buttons for 10 seconds.
When another FRS-200 unit is
calling, you will hear a ringing
sound.
Just push the PTT button on the side
to answer the call.
OPERATION
TO CALL/TO RECEIVE A CALL
FRS.200 Manual 9/22/97 9:04 AM Page 11
