Settings
Your Detector
Nothing
Comes Close to a Cobra
®
19
Settings
Your Detector
18 English
Customizable Display Colors
Your detector includes the
Color Theme
feature that allows you to customize
the display screen color scheme to match your car’s dash illumination:
Multi-Color, Red, Blue, Orange, or Green. The factory setting is Multi-Color.
Display Timeout
Display Timeout
determines how long the Standby screen is illuminated before
switching the unit to Dark. The factory default is 30 seconds.
You can set the time interval to 15 seconds, 30 seconds, one minute, three minutes
or Always On (display never turns Off).
Compass Mode
Your detector includes an internal 8-point magnetic
Compass
that
can continuously display your current direction of travel:
N, NE, E, SE, S, SW, W, or NW.
Before the magnetic compass will work properly,
it must be calibrated
.
Calibration allows the Compass
electronics to measure and store information about the
magnetic fields generated by your vehicle so direction
indications will be accurate. The factory setting
is Compass Off.
A Compass icon and directional heading will appear in the
display when the Compass is On and calibrated.
The Compass will remain accurately calibrated as long as your detector is mounted
in the same place in your vehicle. If you change the location where
the unit is mounted or move it to another vehicle, you must recalibrate the
Compass. You should also recalibrate the Compass if you suspect it is providing
inaccurate directions.
The Compass temporarily may not provide accurate readings if you are inside a
building or enclosure, or are close to a large metal tractor/trailer, truck, or train. Once
you are away from such a location, the Compass will work correctly again.
If the
Optional
GPSL is installed and receiving a signal, its Compass function will
override the magnetic Compass.
Set IntelliMute
After the detector is installed in your vehicle and
IntelliMute
is turned On using
Menu mode, advance to the
Set IntelliMute
setup screen where the activation
point can be set.
From the setup screen:
1.
Press the
City
4
button to advance one screen.
2.
Press and hold the vehicle accelerator at the desired engine RPMs.
3.
Press the
Mute
6
button to complete the setting process.
The system will store the engine RPM setting and provide a completion message
on the display as well as a tone or voice message.
NOTE
If the unit is unable to sense usable pulses within three seconds or if you do not set a
rev point within 30 seconds of beginning the setup, IntelliMute will indicate an error. If
you do not try again within five seconds, it will automatically turn Off. The unit will
provide corresponding messages for these conditions.
Once an activation point has been set, you can easily change it by going directly
to Set IntelliMute in User Settings Menu and repeating the three-step setup
process.
Auto Mute Mode
When
Auto Mute
is On, it automatically reduces the audio volume of all alerts
after they have sounded for four seconds. The signals will remain muted for as
long as the signal is detected. When Auto Mute is Off, the alerts will sound at full
volume for as long as the signal is detected. The factory setting for Auto Mute is
On.
Voice or Tone Mode
You can set your detector to sound alerts and confirm menu settings with either a
Voice
or a
Tone
Alert. Voice Alert provides voice messages in addition to tones.
Tone Alert provides tones only. The factory setting is Voice Alert.
8-Point
Compass
N
S
W
NW
SW
E
NE
SE
