Cobra Moto CX50 BW 2010, Руководство пользователя

Страница: 16 / 78

15
CAUTION:
Use only DOT 4 brake fluid
Setting rear brake pedal position (see figure 2b):
1. Loosen the lock nut (10mm wrench).
2. Adjust the brake lever stop (10mm wrench) so that the lever is comfortably
reachable in both:
a. Standing riding position, and
b. Sitting riding position.
3. Tighten the lock nut (10 mm wrench).
Figure 2b
CAUTION:
Adequate pedal free play is required so that the brake pads do not drag on the
rotor. 1” MINIMUM.
Make sure that the free play locking clip is installed such that one must push
forward, toward the front of the bike, to remove. Otherwise the clip is apt to come
undone while riding.
To adjust (see figure 2b):
1. Loosen the lock nut (10mm).
2. Undo the free play locking clip from around the brake adjustor (plunger),
with your hand by pushing it forward.
3. Slide the pin of the locking free play locking clip from the brake lever
4. Adjust as needed by rotating the clevis on the end of the adjustor
(plunger).
NOTE:
Turning the clevis Clockwise will lengthen the adjustor (plunger), removing free
play from the system, and turning the clevis Counter-Clockwise will shorten the
adjustor (plunger) adding free play to the system.