25
Nothing comes close to a Cobra
®
24 English
Wrist Strap, Belt Clip, Spkr/Mic
Jack and Waterproof Pouch
Installation
Installation
Batteries and Charger Jack
Wrist Strap, Belt Clip, Spkr/Mic Jack and Waterproof Pouch
•
The radio is shipped with a wrist strap, belt clip and waterproof pouch in the
package. The speaker/microphone jack can be used with additional accessories
(see “Optional Accessories” section for optional accessories).
Wrist Strap
Your radio comes with the wrist strap already
attached. It can be easily removed if you choose
not to use it.
Belt Clip
Use the belt clip to carry your radio around with
you. Simply squeeze the clip and place it where
you prefer.
External Speaker/Microphone Jack
Your radio can be fitted with an optional external speaker/microphone
(not included), freeing your hands for other tasks. (For optional accessories,
see “Optional Accessories” section.)
To Attach The External Speaker/Microphone:
1. Open the Speaker/Microphone tab on top
of the radio.
2. Insert the plug into the Speaker/Microphone jack.
Waterproof Pouch
Use the included waterproof pouch to not only keep your radio dry,
but also dust and dirt free.
To Enclose The Radio In The Waterproof Pouch:
1. With the CobraMarine
™
logo facing up,
slip radio, face up, into opening under
Velcro
®
flap at the bottom of the
waterproof pouch.
2. Turn pouch and radio over so that the
CobraMarine
™
logo is facing down.
3. Roll bottom of pouch (between Velcro
®
pieces) towards upper piece of Velcro
®
.
4. Secure bottom piece of Velcro
®
to
upper piece of Velcro
®
.
Batteries and Charger Jack
•
Batteries
To Install Or Replace Batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip down.
2. Pull down on the Battery Door Latch to
remove the battery compartment cover.
3. Insert four (4) AA batteries. (Always use high
quality alkaline batteries.) Position batteries
according to polarity markings.
4. Replace Battery Compartment cover and belt clip.
Charger Jack
When the optional Cobra
®
NiCD rechargeable batteries
(part No. NICB) are used, the batteries can be charged
using the optional Cobra
®
Wall Mount Charger (part
No. WWC). Simply place the Cobra
®
NiCD rechargeable
batteries (part No. NICB) in the battery compartment,
open the Charge Tab on the side of the unit and insert the
plug into the charge jack to start charging. The batteries
should be fully charged in about eight (8) hours.
WARNING
Only the Cobra
®
NiCD rechargeable batteries,
part No. NICB (see “Optional Accessories” section),
can be recharged.
NOTE
See information on page 40 for optional
charger accessories ordering instructions.
Maintaining the Battery Charge
As you use your radio, the battery power icon will
show the battery power remaining. When the icon
shows only one or no segment, it is time to change
the batteries.
Remove Belt Clip
Remove Battery Cover
Insert Four (4) Batteries
Belt Clip
Speaker/Microphone Tab
Waterproof Pouch
Wrist Strap
Fully Charged
