COBHAM SAILOR 900 Ka, Руководство по установке

Страница: 61 / 182

98-146706-A 6-1
Chapter 6
Confi
guration
Configuration
6
This chapter has the following sections:
• Introduction to the built-in web interface
• Calibration
• Configuration with the web interface
• Keypad and menus of the ACU
•
SNMP support
6.1 Introduction to the built-in web interface
6.1.1 Overview
Use the built-in web interface (installation of software is not necessary) of the SAILOR 900
Ka ACU to make a full configuration of the SAILOR 900 Ka. You can use a standard Internet
browser.
For quick start instructions see Calibration on page 6-3.
6.1.2 Connecting to the web interface
To connect to the web interface of the ACU do as follows:
1. Switch on the ACU. Wait until the LEDs on the front plate of the ACU show that the
system is ready to be configured.
• Power LED: Green
• Logon LED: Off
• Fail/Pass LED: Flashing green during power-on self test, after that steady green.
2. Connect a PC to LAN port 3: Service (standard Ethernet) of the ACU or to the front LAN
connector of the ACU.
Important
The SAILOR 900 Ka system is not designed to be connected
directly to the Internet. It must be located behind a
dedicated network security device such as a fire wall.
If any ports of the SAILOR 900 Ka are exposed to the
Internet you must change the default passwords as anyone
with access and malicious intent can render the SAILOR 900
Ka inoperable.
SAILOR900Ka-IM-98-146706.book Page 1 Thursday, July 16, 2015 11:07 AM