8
6.1.13 Connect the GPS and GSM antenna to the right connector, and find an appropriate
place to fix the antennas to make sure good reception.
6.2 SIM card installation
6.2.1 Use a tweezers or a sharp thing to touch the SIM CARD popup switch, the SIM
CARD slot will pop up, take out the SIM card slot to load the SIM card, and then put
the SIM card slot back to its original position after confirm the SIM card in the right
place.
6.2.2 Please make sure that the SIM card is able to execute the function of incoming calls
display, no calls can be diverted and the PIN code is locked. The SMS format must be
TXT format, and can’t recognize the PDU format.
6.3 Turn on the tracker device
6.3.1 Connect the positive and negative wire, red and black ones, with 12V or 24V car
power system, wait for 1 minute after connecting power to wait tracker works
normal, and then turn on the backup battery switch.
6.4 GSM/GPS LED Indicator
6.4.1 Red LED indicator on: No GSM network signals.
6.4.2 Red LED indicator flashes fast (one time each second): GSM Network signal is
normally, and tracker works under SMS mode.
6.4.3 Red LED indicator flashes slowly (one time each three second): Tracker works
under GPRS mode.
6.4.4 Green LED flashes slowly: GPS signal is normal.
6.4.5 Green LED indicator off: No GPS signals.
6.4.6 The red and green indicators flash three times alternately: it means tracker has been
detected the SD card.
6.5 Initialization
Send SMS “begin+password” to the unit, it will reply “begin OK” and initialize all
the settings to default factory settings.
(
default password: 123456
)
For example: Send SMS “begin123456”, it will reply “begin ok”. (No quotation marks
“”when sending all the SMS)
6.6 Change Password
6.6.1 Send SMS “ pold pspace+new password” to the unit to change
the password.
For example: send SMS “password123456 888888” to the unit. If succeeded,
“Password ok” will reply to your cell phone.
6.6.2 Keep the new password in mind, or the machine will not work properly if lost the
password.