Cobalt Digital Inc OG-PC-x86-A, Руководство по эксплуатации продукта, Страница: 15 / 26

OG-PC-X86A-OM (V1.0) OG-PC-X86-A PRODUCT MANUAL
2-3
Installation
Installing Rear I/O Module
CAUTION
Make certain HD Piggyback Board power harness leads are positioned around
standoff and not pinched between standoff and piggyback PCB.
7.
Carefully align HD Piggyback Board in mounting position on the six (6)
peripheral mounting standoffs. Start six (6) securing screws.
8.
Fully tighten six (6) HD Piggyback Board securing screws.
Installing Rear I/O Module
CAUTION
Make certain Rear I/O Module is installed before installing the OG-PC-x86-A
into the frame slot. Damage to card and/or Rear I/O Module can occur if
module installation is attempted with card already installed in slot.
The Rear I/O Module provides the user “rear panel” connection breakouts for
the OG-PC-x86-A assembly. Install Rear I/O Module as follows:
1.
On the frame, determine the slot in which the OG-PC-x86-A is to be
installed.
Note: Although an OG-PC-x86-A can be installed anywhere in the frame, typically it
is recommended to select a group of slots at the left-most or right-most of
available slots. The OG-PC-x86-A and its mating rear I/O module will require
four (4) slots (example: OG-PC-x86-A and rear I/O module positioned to use
slots 17 thru 20 in the 20-slot frame).
2.
In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-2.